Analysers Online
Analysers Online Header Image
Analysers Online

QuickTOCeffluent TOC Analyser

  • Measurement range: 0.1 - 200 mg/l
  • Response time: 2-3 min
  • TC, TOC monitoring
  • Easiest calibration and validation (QuickCalibration)
  • Highest combustion temperature (1,200°C) on the market
  • Catalyst-free technique
  • No filtration necessary at the effluent
  • No memory effects
  • Low operational and maintenance costs
  • According to DIN EN 1484:1997-08, ISO 8245:1999-03 and EPA 415.1




  • Municipal WWTP outlet
  • Industrial WWTP outlet
  • Process water
  • Detailed application overview
  • Combination with TNb detection
  • IP54 (Standard)
  • NEMA 4X
  • ATEX Zone I
  • ATEX Zone II

Online-TOC-Measurement for waster water treatment plants. Especially for the effluent.

LAR's QuickTOCeffluent is the ultimate online TOC analyser for the determination of total organic carbon (TOC) for waste water treatment plants effluents.

Warm, warmer, hot. Tracking organic load at 1,200°C.

The catalyst-free ceramic oven is the centrepiece of the QuickTOCeffluent. At 1,200°C, it reliably dissolves all carbon bonds and thus enables a complete analysis of samples. Despite the high temperatures used, absolute safety is guaranteed in all settings. For this end, the QuickTOCeffluent can be delivered with a number of different housings, depending on the intended location. That way the analyser itself can be safely at high corrosive places as well as in Ex-Zones.

Catalysts. For our analysers simply not necessary.

Lower temperatures at 680-1,000°C need catalysts to provide satisfying oxidation power. Even then complex compounds often are not determined. Because of the high temperature the QuickTOCeffluent does not need any catalysts.

The QuickTOCeffluent. Ultra quick measurements and maintenance.

The TRUE TOC measurement takes place in less than 3 minutes. This speed guarantees that very short peaks can be determined very well during a daily cycle. The analyser's availability is over 98%.

The loop injection. For clean sample dosage.

The sample is injected into the furnace via an injection loop. Moreover, this loop defines simultaneously the sample volume. The loop system ensures that the sample is 100% closed against ambient air. Even the smallest impurities are excluded. The sample can be analyzed correctly in the lowest ppb range.